Avanti Refrigerator Avanti Products Refrigerator User Manual

0

Out of 0 Ratings

Owner's of the Avanti Refrigerator Avanti Products Refrigerator gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 24
 
11
and the green LED lamp marked “WHITE” will be lit.
When you store mostly sparkling wines, the temperature needs to be set at between 40 to 47F/5
to 8ºC and the amber LED lamp marked “SPARKL” will be lit.
NOTE:
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting
the unit. If you attempt to restart before this time delay, the Wine Chiller will not start.
When you use the wine chiller for the first time or restart the wine chiller after having been shut off
for a long time, there could be a few degrees variance between the temperature you select and
the one indicated on the LED readout. This is normal and it is due to the length of the activation
time. Once the wine chiller is running for a few hours everything will be back to normal.
STORAGE
Many bottles may differ in size and dimensions. As such the actual number of bottles you may be able
to store may vary.
NOTE: You can place approximately 50 standard bottles (750ml capacity) in your unit.
INTERIOR LIGHT
If you would like the light ON press the button and the interior light will be turned ON. The light
will automatically turn OFF after 10 minutes.
INSTALLING STAINLESS STEEL HANDLE
This wine chiller includes a stainless steel handle that is not required to operate this unit. To install the
handle please follow the below instructions:
1. Pull away the door gasket in the area where the handle is to be installed as shown below in
Illustration # 1. The gasket is easily displaced by hand, no tools are necessary.
2. Align the handle with the screws pre-installed on the backside of the door. Tighten the
screws using a Phillips head screwdriver until the handle sets both flush and secured tightly
against the door frame. (DO NOT overtighten as this will cause damage to the handle
assembly).
3. Replace the door gasket to its original position.
1 2
1 Gasket 2 Screw 3 screwdriver 4 S/S Handle

   Find Your Products By Category