Avanti Refrigerator Avanti Products Refrigerator User Manual

0

Out of 0 Ratings

Owner's of the Avanti Refrigerator Avanti Products Refrigerator gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 20
 
9
INSTALLATION INSTRUCTIONS
BEFORE USING YOUR BEVERAGE COOLER
• Remove the exterior and interior packing.
• Check to be sure you have all of the following parts:
1
Instruction Manual
3
Beverage Shelves
2
Keys
1 Set
Stainless Steel Hinges for Door Swing Reversal
2
Hinge Screw caps
1
Stainless Steel Handle
• Before connecting this appliance to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
INSTALLATION OF YOUR BEVERAGE COOLER
• This appliance is designed to be for free standing installation or built-in (fully recessed).
• Place your Beverage Cooler on a floor that is strong enough to support it when it is fully
loaded. To level your Beverage Cooler, adjust the front leveling legs at the bottom of the
Beverage Cooler.
• Locate the Beverage Cooler away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extreme cold ambient temperatures may also cause the unit not to
perform properly.
• Avoid locating the unit in moist areas.
• Plug the Beverage Cooler into an exclusive, properly installed-grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified electrician
or an authorized Avanti Products service center.
BUILT – IN CABINET INSTRUCTIONS
This unit is designed for both built-in or free standing installation. If you plan to use this unit in a built-
in application please follow the requirements shown to the right.
← Figure shown
Cabinet Opening Dimensions
IN (min)
MM (min)
Width
24”
610 mm
Depth
26”
661 mm
Height
35”
889 mm
Figure shown →
Unit Dimensions
IN (min)
MM (min)
Width
23
2
/
5
”
595 mm
Depth
(with handle)
24
2
/
5
”
620 mm
Depth
(without handle)
22
3
/
4
”
575 mm
Height
34 ¼”
870 mm

   Find Your Products By Category