Avanti Beverage Dispenser PARTY PUB User Manual

5.0

Out of 1 Ratings

Owner's of the Avanti Beverage Dispenser PARTY PUB gave it a score of 5.0 out of 5. Here's how the scores stacked up:

  • Reliability

    5.0 out of 5

  • Durability

    5.0 out of 5

  • Maintenance

    5.0 out of 5

  • Performance

    5.0 out of 5

  • Ease of Use

    5.0 out of 5
of 28
 
14
• Unlock the dispensing head from the keg by pushing the catch and
remove the piercing pin from the keg.
b) To clean the beer lines
• Fill the cleaning bottle supplied with your appliance half-way with lukewarm water. As
required, you may add a bit of detergent. Push it firmly onto the dispensing kit.
• Reconnect the hoses on the dispensing kit as indicated in section "Setting up the keg".
• Open the valve of the pressure gauge and set the pressure to 1.0 bar for 5 seconds and then
close the valve again immediately.
• Pull the tap handle towards you and allow the cleaning solution to flow completely.
• Once you have completely finished all of the cleaning solution, rinse the appliance using the
same method but with clean water.
• Pull on the tap handle to empty the cleaning bottle and release the remaining gas.
• The various Party Pub accessories are not designed to be washed in a dishwasher.
c) To clean the Party Pub exterior surfaces.
• Before cleaning the appliance, it is essential to turn off the main switch and then pull the plug
out of the socket.
• The drip tray and cover can be removed from the unit either separately or together by pulling
it away from the unit. After cleaning the tray and cover can be returned to place in the
reverse manner.
Failure to unplug the Party Pub could result in electrical shock or personal injury.
CAUTION
Storage
When the appliance is not used for a long period of time. Store the appliance in a dry place out of
children’s reach.
PROBLEMS WITH YOUR APPLIANCE?
You can solve many common unit problems easily, saving you the cost of a possible service call. Try
the suggestions below to see if you can solve the problem before calling the servicer.
TROUBLESHOOTING GUIDE
PROBLEM
POSSIBLE CAUSE
Unit does not operate.
Unit is not plugged in.
The circuit breaker tripped or a blown fuse.
Unit is not cold enough.
Check the temperature control setting.
External environment may require a higher
setting.
The door is opened too often.
The door is not closed completely.
The door gasket does not seal properly.
The unit does not have the correct clearances.
Abnormal voltage.
Vibrations.
Check to assure that the unit is level.
The light does not work.
Not plugged in.
The circuit breaker tripped or a blown fuse.
The light button is “OFF”.

   Find Your Products By Category